CAN-CR110/FO, 2 ports, 1 x screw terminal with CAN-terminati
CAN-CR110/FO repeater with two CAN/CAN FD interfaces, one of which is a Fiber Optic interface, enables the conversion of CAN signals from copper wire to fiber optics. With integrated termination resistors, DIN Rail mount
The Ixxat CAN-CR110/FO repeater with two CAN/CAN FD interfaces, one of which is a Fiber Optic interface, enables the conversion of CAN signals from copper wire to fiber optics. It enhances connectivity in high-electromagnetic interference zones and provides the flexibility to optimize network structures. With integrated termination resistors.
Features and benefits
Robust industrial use
Designed for industrial environments, meeting high demands for robustness, temperature ranges, and safety.
Flexibility in CAN FD network design
Helps to optimize CAN/CAN FD network structures by enabling extended layouts (stub lines, star and tree topologies).
Fast and transparent operation
Minimal impact on real-time behavior, equivalent to a short line length (ca. 60 m/300 ns delay). Enabling transparent transmission, compatible with all higher layer protocols.
Cost savings due to simple wiring
Optimized topologies enable simpler wiring, resulting in less cables and cost savings at installation and maintenance.
Enhanced network reliability
Higher system reliability by electrically isolating CAN/CAN FD segments and power up to 1 kV. This enhances the protection of the device against damage to electronics caused by voltage peaks.
Network monitoring and fault recovery
In case of disturbances, the repeater automatically disconnects the affected segment and restores it after the fault is resolved.
Robust fiber optic interface
Fiber optic ensures uninterrupted data transmission in high-electromagnetic disturbance zones, enabling enhanced connectivity for critical applications and high performance.
Integrated bus termination resistors
Integrated bus termination resistors prevent reflections on the line ends and ensure optimum communication.