CAN-CR100 Without bus termination resistor
The Ixxat CAN-CR100 repeater with two CAN/CAN FD interfaces improves the CAN bus load capacity, establishes a physical coupling of bus systems and offers galvanic isolation, DIN Rail mount
The Ixxat CAN-CR100 repeater with two CAN/CAN FD interfaces improves the CAN bus load capacity, establishes a physical coupling of bus systems and offers galvanic isolation. It provides the flexibility to optimize network structures and liberates them from CAN bus structure constraints for optimized operation.
Features and benefits
Robust industrial use
Designed for industrial environments, meeting high demands for robustness, temperature ranges, and safety.
Flexibility in CAN FD network design
Helps to optimize CAN/CAN FD network structures by enabling extended layouts (stub lines, star and tree topologies).
Fast and transparent operation
Minimal impact on real-time behavior, equivalent to a short line length (ca. 35 m/175 ns delay). Enabling transparent transmission, compatible with all higher layer protocols.
Cost savings due to simple wiring
Optimized topologies enable simpler wiring, resulting in less cables and cost savings at installation and maintenance.
Enhanced network reliability
Higher system reliability by electrically isolating CAN/CAN FD segments and power up to 1 kV. This enhances the protection of the device against damage to electronics caused by voltage peaks.
Network monitoring and fault recovery
In case of disturbances, the repeater automatically disconnects the affected segment and restores it after the fault is resolved.